CCTV drainage surveys
Drain CCTV
An orange vacuum tanker with a suction hose running to a drain beside a building.

CCTV drainage surveys

Drainage Investigation

A drainage investigation starts from a symptom and works towards a cause. We can help with camera work, tracing, dye testing and flow checks on recurring blockages, smells, wet ground and drainage that only misbehaves in heavy rain.

What a drainage investigation sets out to find

A drainage investigation is diagnostic work. The question is not what condition the system is in, but why something keeps happening: why a gully floods in heavy rain, why a kitchen drain blocks every few weeks, why a smell appears in one room, or why a patch of ground stays wet in dry weather. The survey work may involve similar methods to a camera inspection, but the purpose changes what is done and in what order.

We can help with drainage investigations on domestic, commercial and industrial sites. The aim is to identify a cause supported by evidence, or establish what has been ruled out and what further checks would help settle the remaining question. A condition record that simply lists observations is a different piece of work, covered on our drainage survey page.

A large black corrugated pipe at the edge of a lined water lagoon.

Symptoms that usually start an investigation

The symptom shapes the method, so it is worth describing it properly before anyone attends.

  • A blockage that returns after clearing, in the same place or at the same interval
  • Flooding or surcharging that only happens during or shortly after heavy rain
  • Smells indoors or around a yard with no obvious source
  • Wet ground, soft paving or vegetation growing strongly along a pipe run
  • Rats appearing inside a building or in a yard
  • Damp or movement in a structure where drainage is one of the possible causes being checked

Each of those points towards a different starting place. A blockage that returns repeatedly may indicate a pipe defect, a fall problem or a build up of material that has not been fully removed. A problem that only appears in rain may involve surface water, infiltration or a connection carrying more water than the system can discharge effectively. The investigation needs to distinguish between those possibilities rather than assume a cause from the symptom alone.

Establishing the layout first

Camera footage is much more useful when the pipe being inspected can be identified on the drainage layout. The first stage is normally to lift accessible inspection chamber covers, record which pipes enter and leave each chamber, and establish the direction of flow. On sites that have been altered or extended, this can help explain the problem, particularly where drainage runs have been connected or diverted without an updated plan.

Where no usable plan exists, tracing the system is a job in itself. Our drain mapping page covers how runs and chambers are recorded, including what public records do and do not show.

Tracing, dye testing and flow checks

Once the layout is understood, the methods are chosen to answer a specific question rather than to produce a general survey. Not every investigation needs every test. The checks depend on the reported fault, available access and what can already be established from the drainage layout.

Camera work

A camera pass records the visible internal surface and can locate a defect by distance along the run. In an investigation it may be useful to inspect the pipe twice: once as found, to see what the system looks like in service, and again after cleaning, because deposits can hide the invert. The footage can show root ingress, displaced joints, fractures, deposits or standing water, although the significance of each observation depends on the problem being investigated. Our CCTV drain inspection page covers the equipment side.

Dye testing

Dye testing helps establish where a particular inlet discharges. It can be used to check whether a gully, downpipe or appliance is connected to the expected drainage run and to investigate possible connections between foul and surface water systems. Where dye is observed at the expected outlet, it supports the identification of that flow route. A negative result does not always disprove a connection, because dye can be diluted, retained or diverted. See drain dye testing for how it is carried out.

Flow and water tests

Introducing water into a system and observing where it goes helps show how the drainage behaves rather than just how it looks. Depending on the arrangement, this may reveal restricted flow, standing water, a partial blockage that becomes more noticeable under load, or a chamber that begins to back up. Poor falls can also be suspected from the results, although confirming the gradient may require separate level measurements.

A valve and pipework above a bed of dried deposits in a concrete tank.

Reading the evidence

Drainage findings need to be considered together, because an observation on its own does not always establish the cause. A displaced joint with roots at the same distance as a repeated blockage may explain why the obstruction returns. Silt in a long, flat run can suggest poor flow conditions or the way the drainage is being used. Water standing in a chamber downstream of an apparently clear pipe may point towards a restriction further along the system.

The report should distinguish between what the camera or testing has directly established and what is still a possible explanation. Where the available evidence does not settle the cause, further checks can be identified rather than presenting a suspected fault as confirmed.

Where the investigation leads towards a public sewer, the ownership and maintenance responsibility need to be established. Many formerly private sewers and lateral drains in England and Wales transferred to sewerage companies in 2011 under the private sewers transfer regulations. Responsibility depends on the classification and ownership of the particular pipe, not simply whether a defect lies beyond the property boundary. Identifying the affected run and locating the defect helps establish who should be contacted.

When excavation is the right next step

Excavation may be needed where a defect cannot be fully assessed or dealt with from inside the pipe. Before recommending it, the investigation should establish as much as possible about the position, depth and nature of the problem. A camera may show a damaged section, but it cannot directly establish the condition of the surrounding ground or every aspect of the pipe structure.

Before that point, consider whether a second camera pass after cleaning, a dye test or a sonde location would answer the same question. Our collapsed drain guide covers the situations where a pipe has failed structurally and excavation or lining may be considered, depending on the extent and condition of the damage.

Investigations connected to flooding or a claim

Where flooding is involved, more than one organisation may have a part to play. The government guidance on reporting a flood or possible cause of flooding explains who to contact about blocked public sewers, public drains, flooded roads and watercourses. The source of the flooding matters when deciding whether the problem belongs within private drainage or another drainage system.

Where an insurer or loss adjuster is involved, the investigation should provide a record of the evidence rather than relying on an unsupported conclusion. Located observations, relevant footage, test findings and a record of what has been ruled out help explain the findings. Our page for insurers and loss adjusters covers how drainage findings sit alongside the rest of a claim.

What the report should say

An investigation report is most useful when someone else can follow the reasoning. It should record the symptom as reported, the sequence of checks carried out, what each one showed, the conclusion reached and the evidence supporting it. Where a cause has not been established, recording what has been excluded and what remains uncertain is more useful than recommending a repair without sufficient evidence.

Photographs, camera footage, pipe references, chamber locations and relevant measurements can help connect the findings to the actual drainage system. The level of detail depends on the purpose of the investigation and what access and testing allow.

If the findings will later be used for a repair quotation, an adoption question or a landlord record, it is useful to establish that before the work starts, because it affects which observations and supporting details need to be recorded. Our drainage compliance report page covers specifying the document.

What affects the scope of an investigation

Investigation work is harder to scope than a condition survey, because the next step depends on what the previous checks reveal. The main factors are the size and complexity of the system, how much layout information already exists, how many access points are available, whether cleaning is needed before the pipe can be inspected properly, and whether the symptom is intermittent.

A drainage fault that appears whenever an appliance discharges may be easier to reproduce than flooding that occurs only during particular rainfall conditions. Likewise, a single blocked domestic run presents a different investigation from a site with several connected drainage networks and incomplete plans.

An intermittent problem may not appear during a single visit. In that situation, the findings should explain what was observed under the conditions available and what remains unresolved. The purpose is to identify the cause where the evidence allows, or narrow down the fault sufficiently for an informed decision about further investigation or repair.

Free online tool

Build Over Agreement Checker

Building over or near public drains and sewers

Use the checker

Common questions

Frequently asked questions

What is the difference between a drainage investigation and a drain survey?

A survey records condition, usually across an agreed set of runs. An investigation starts from a symptom and uses whichever checks answer it, which may mean inspecting one run twice and leaving unrelated runs out of the scope. The outputs differ too: a survey lists observations, while an investigation sets out the reasoning and findings.

My drain blocks every few weeks. What would you look for?

A repeating blockage in the same place can be caused by roots at a joint, a displaced or dropped section, a flat or reversed fall, or a build up that forms again because the run does not clear properly. Camera inspection before and after cleaning can help distinguish between these possibilities, particularly where deposits hide the invert.

Can an investigation find a leak under a building?

It may locate a pipe defect beneath a building using camera work and a sonde, providing a position and an approximate depth where access and conditions permit. A camera cannot show the surrounding ground or directly measure how much water is escaping. Those questions may require other investigation methods alongside the drainage work.

Do I need to clean the drains before an investigation?

Not always, and seeing the system in its working state is sometimes the point. Where deposits or standing water hide the pipe, cleaning followed by a second pass can give a clearer record. Cleaning changes what the camera can see, not the underlying condition of the pipe, and the report should record when it happened.

What if the problem turns out to be in a public sewer?

Locating the defect and recording which run and chamber it sits in helps establish whether it should be raised with the sewerage company. Many formerly private sewers and lateral drains in England and Wales transferred to sewerage companies in 2011. Responsibility depends on the ownership and classification of the pipe rather than the property boundary alone.

Can you investigate a problem that only happens in heavy rain?

Yes. A fault associated with heavy rain may involve surface water, infiltration, restricted discharge or a drainage system receiving more water than it can carry effectively. Dye testing and flow checks may help investigate the connections and behaviour, although the exact conditions that cause an intermittent problem may not be present during the inspection.

Drain CCTV

Discuss your project with us

0330 350 3692

Request a quote

Complete the form and we will get back to you.

Request a quote